Gate Bias Circuit:

Circuit Operation – Consider the Gate Bias Circuit shown in Fig. 10-6. The FET gate terminal is connected via resistor RG to a bias voltage VG. If the gate is directly connected to the bias source (instead of using RG), any ac signal applied to the gate would be short-circuited to VG.

 Gate Bias Circuit

There is no gate current to produce a voltage drop across RG so the gate-source voltage remains constant at VG. Depending on the device transfer characteristics, VG sets the level of ID in the FET.

The ID level can be readily determined, if the transfer characteristic is available for the particular FET used in the circuit. If the device is replaced, ID is determined by the transfer characteristic of the new device. Like the base current in a BJT base bias circuit, the FET gate voltage does not change when the device characteristics change.

Circuit Analysis:

As discussed already, each FET of a given type number has maximum and minimum transfer characteristics, and these must be employed to determine the maximum and minimum possible levels of ID in the circuit. A Gate Bias Circuit is most easily analyzed by drawing a bias line vertically on the transfer characteristics from VGS = -VG. The levels of ID(min) and ID(max) are read from the intersections of the bias line with the transfer characteristics, and the maximum and minimum drain-source voltages can then be calculated using these ID levels.

Gate Bias Circuit

The maximum and minimum ID and VDS levels determined are illustrated by the circuit current and voltage levels in Fig. 10-8, and by the Q-points plotted in Fig. 10-9. As already discussed, JFETs with a given type number have a wide range of transfer characteristics, so

PET maximum and minimum transfer characteristics should always be used for practical circuit analysis. 

The gate bias technique produces a wide range of ID and VDS levels for any FET with a particular type number. It is possible to adjust VG to set VDS to a desired voltage. However, this is normally done only in an experimental situation. Slightly more complicated bias circuit must be employed for more predictable voltage and current conditions.

Gate Bias Circuit

Analysis of a Gate Bias Circuit can be performed without drawing the FET transfer characteristics.

Gate Bias for a p-channel JFET:

Gate Bias Circuit

A gate bias circuit using a p-channel JFET is shown in Fig. 10-­10(a). This is similar to n-channel JFET Gate Bias Circuit except that VDD is a negative voltage and VG is a positive quantity. Figure 10-10(b) shows the same p-channel JFET circuit with a positive supply voltage. In this case, the FET source terminal is connected to VDD, and RD is connected to ground. To reverse bias the gate channel junctions, the gate terminal must be positive with respect to the source. So, gate bias voltage VG must be positive with respect to VDD, as illustrated. The p-channel gate bias circuit can be analyzed in exactly the same way as an n-channel circuit.

Related posts:

  1. FET Biasing Methods – Fixed Bias, Self Bias, Potential Divider Bias and Current Source Bias
  2. Self Bias or Potential Divider Bias Circuit
  3. Common Gate Circuit
  4. CMOS NAND Gate Circuit Diagram
  5. CMOS NOR Gate Circuit
  6. Common Gate JFET Amplifier and its AC Equivalent Circuit
  7. Gate Controlled Switch (GCS) Circuit – Operation and Advantages
  8. Gate Turn Off Thyristor (GTO) – Symbol, Operations and Applications
  9. Insulated Gate Bipolar Transistor (IGBT)
  10. Gate Firing Converters
  11. Gate Function in Network Function
  12. Dual Gate MOSFET – N Channel Depletion Type MOSFET
  13. Collector to Base Bias Circuit
  14. Voltage Divider Bias Circuit
  15. BJT Bias Circuit Troubleshooting
  16. Bias Circuit Design
  17. Bias Circuit Thermal Stability
  18. Fixed Bias Circuit Diagram – Advantages and Disadvantages
  19. Emitter Bias Circuit Diagram
  20. Base Bias with Collector Feedback Circuit