Collision Process in Gases: An electrical discharge is normally created from unionised gas by Collision Process in Gases. These processes are mainly gas processes which occur due to the collision between the charged particles and…
Voltage Transformer Earthing: In this method of neutral earthing, the primary of a single-phase Voltage Transformer Earthing is connected between the neutral and the earth as shown in Fig. 26.17. A low resistor in series…
Resonant Grounding or Arc Suppression Coil Grounding: We have seen that capacitive currents are responsible for producing arcing grounds. These capacitive currents flow because capacitance exists between each line and earth. If inductance L of appropriate…
Resistance Grounding: In order to limit the magnitude of earth fault current, it is a common practice to connect the neutral point of a 3-phase system to earth through a resistor. This is called Resistance…
Solid Grounding or Effective Grounding: When the neutral point of a 3-phase system (e.g. 3-phase generator, 3-phase transformer etc.) is directly connected to earth (i.e. soil) through a wire of negligible resistance and reactance, it…
Neutral Grounding: The process of connecting neutral point of 3-phase system to earth (i.e. soil) either directly or through some circuit element (e.g. resistance, reactance etc.) is called Neutral Grounding. Neutral grounding provides protection to…
Ungrounded Neutral System: In an ungrounded neutral system, the neutral is not connected to the ground i.e. the neutral is isolated from the ground. Therefore, this system is also called isolated neutral system or free…
System Grounding: The process of connecting some electrical part of the power system (e.g. neutral point of a star-connected system, one conductor of the secondary of a transformer etc.) to earth (i.e. soil) is called…
Grounding or Earthing: The process of connecting the metallic frame (i.e. non-current carrying part) of electrical equipment or some electrical part of the system (e.g. neutral point in a star-connected system, one conductor of the…
Key Diagram of Substation 66/11KV: Fig. 25.10 shows the key diagram of a typical 66/11 kV sub-station. The Key Diagram of Substation can be explained as under: 1. There are two 66 kV incoming lines…
