Autotransformer | Definition | Use of Auto transformer: So far two-winding transformers have been discussed wherein the windings are electrically isolated. When the primary and secondary windings are electrically connected so that a part of…
Switching Transients in Transformer | Transformer Inrush Current: Switching Transients in Transformer - In the earlier discussion earlier steady-state operation was assumed so that v1 and Φ are both sinusoidal, Φ lagging v1 by 90°…
Excitation Phenomenon in Transformer: It was stated already that the no-load current in a transformer is nonsinusoidal. The basic cause for this Excitation Phenomenon in Transformer, which lies in Transformer Hysteresis and Saturation nonlinearities of…
Voltage Regulation Formula of Transformer: Voltage Regulation Formula - Constant voltage is the requirement of most domestic, commercial and industrial loads. It is, therefore, necessary that the output voltage of a transformer must stay within…
Transformer Efficiency Formula: Power and distribution transformers are designed to operate under conditions of constant rms voltage and frequency and so the efficiency and voltage regulation are of prime importance. Transformer Efficiency Formula is the…
Per Unit System: While carrying out the analysis of electrical machines (or electrical machine systems), it is usual to express voltage, current, VA and impedance in Per Unit System (or percentage) of the base or…
Sumpner Test of Transformer: While OC and SC tests on a transformer yield its equivalent circuit parameters, these cannot be used for the 'heat run' test wherein the purpose is to determine the steady temperature…
Transformer Testing Methods: Two chief difficulties which do not warrant the Transformer Testing Methods by direct load test are: Large amount of energy has to be wasted in such a test, It is a stupendous…
Different types of losses in transformer: The transformer has no moving parts so that its efficiency is much higher than that of rotating machines. Different types of losses in transformer are enumerated below: Core Loss…
Transformer Nameplate Rating: Transformer Nameplate Rating Details - The voltage ratio is specified as V1 (rated)/V2 (rated). It means that when voltage V1 (rated) is applied to the primary, the secondary voltage on full load…
