Data Types and Instruction Set of 8087 co-processor: The Data Types and Instruction Set of 8087 co-processor can support 7 different data types namely Three Signed Integers 16-bit (word) - range 32768 to + 32767…

Pin Diagram of 8087 Processor: Figure 7.46 shows the pin diagram of 8087 processor. The operations of all pins of 8087 are explained below: AD15-AD0 The AD15-AD0 are the time multiplexed address/data lines. During T1, these lines…

8087 Numeric Data Processor: The 8087 Numeric Data Processor (NDP) is called a high-speed math co-processor. This math co-processor is also known as Numeric Processor Extension (NPX) or Numeric Data Processor (NDP) or Floating Unit…

8288 Bus Controller: Figure 5.37 shows the 8288 bus controller which is used in the maximum-mode operation of 8086 CPU. This IC receives four inputs such as S̅2, S̅1, S̅0 status signals and CLK from 8086.…

Clock Generator 8284A: During fetch and execute instructions, the 8086 and 8088 processors require clock pulse which has about 10 ns rise and fall times. The logic 0 level of the clock is 0.5 V…

Demultiplexing of Address and Data Bus in 8086 and 8088 Microprocessors: Demultiplexing of Address and Data Bus in 8086 and 8088 Microprocessors which consists of three buses: address, data and control buses. The address/data buses…

Timing Diagram of the 8088 Microprocessor: Each bus cycle of the 8088 processor consists of four T states: T1, T2, T3 and T4. During the first clock cycle T1, ALE signal is high and A19/S6-A16/S3 are used as…

Internal Architecture of 8088 Microprocessor: Figure 5.24 shows the Internal Architecture of 8088 Microprocessor. The set of registers of 8088 is approximately same as that of 8086. The architecture of 8088 is same as 8086…

Time Delay Loop in Microprocessor: Microprocessors perform different operations in sequence and one operation at a time. To complete an opera­tion, some time is required. When some time delay is required between two operations, a…