Ideal Transformer on Load
Ideal Transformer on Load: Transfer of energy from one circuit to another circuit through mutual induction is widely utilized in power systems. This purpose is served by Ideal Transformer on…
Ideal Transformer on Load: Transfer of energy from one circuit to another circuit through mutual induction is widely utilized in power systems. This purpose is served by Ideal Transformer on…
Coefficient of Coupling: The amount of coupling between the inductively coupled coils is expressed in terms of the coefficient of coupling, which is defined as where M = mutual inductance…
Dot Convention in Coupled Circuits: Dot Convention in Coupled Circuits is used to establish the choice of correct sign for the mutually induced voltages in coupled circuits. Circular dot marks…
Mutual Inductance of Coupled Circuits: Mutual Inductance of Coupled Circuits - A voltage is induced in a coil when there is a time rate of change of current through it.…
Reactive Power with Wattmeter: We have already seen earlier that the difference between higher reading wattmeter and lower reading wattmeter yields VLIL sin Φ. So, the total reactive power =…
Power Factor by Two Wattmeter Method: When we talk about the power factor in three-phase circuits, it applies only to balanced circuits, since the power factor in a balanced load…
Three Wattmeter and Two Wattmeter Method: In this method, the three wattmeter are connected in the three lines as shown in Fig. 9.45, i.e. the current coils of the three…
Power in Three Phase Circuits: Measurement of power by a wattmeter in a single phase circuit can be extended to measure Power in Three Phase Circuits. From earlier Section, it…