Protection of Alternators
Protection of Alternators: The generating units, especially the larger ones, are relatively few in number and higher in individual cost than most other equipment's. Therefore, it is desirable and necessary…
Protection of Alternators: The generating units, especially the larger ones, are relatively few in number and higher in individual cost than most other equipment's. Therefore, it is desirable and necessary…
Power Factor Improvement: The low power factor is mainly due to the fact that most of the power loads are inductive and, therefore, take lagging currents. In order for Power…
Inverter Control using Terminal Voltage Sensing: The Inverter Control using Terminal Voltage Sensing of the synchronous motor is obtained using the triggering pulses to the inverter which are synchronized with…
Function Generation and Linearisation: An important aspect of the closed loop control system is the use of Function Generation and Linearisation, e.g. in the control of induction motors there exists…
Introduction to Microprocessors and Control of Electric Drives: Introduction to Microprocessors and Control of Electric Drives - Conventionally, control of thyristor converter fed electrical drives (both dc and ac) is…
Turbocompressors: The turbocompressors and blowers in the industry require drives rated up to 40 MW. Drives of large rating are also required in steel industry blast furnace blowers in natural…
Paper Mill Process: The raw materials for Paper Mill Process undergo two processes before the paper is available: The pulp is made from the raw materials. This pulp is converted…
Sugar Mill Process: The Sugar Mill Process the crystals are separated from the syrup by means of a centrifuge. The separation is accomplished by the centrifugal forces set up. The…