Economic Choice of Transmission Voltages
Economic Choice of Transmission Voltages: It has been shown earlier here that if transmission voltage is increased, the volume of conÂductor material required is reduced. This decreases the expenditure on…
Economic Choice of Transmission Voltages: It has been shown earlier here that if transmission voltage is increased, the volume of conÂductor material required is reduced. This decreases the expenditure on…
Choice of Electronic Signal Transmission: The range of air pressure used for Signal Transmission in pneumatic system is limited by the dynamic operating range of the pneumatic devices used. But…
Data Transmission System: A typical data transmission system contains the information source from which data has to be transmitted through a suitable medium to the destination, termed the information sink.…
Limitations for Loading Capability of Transmission System: There are three kinds of limitations for loading capability of transmission system: Thermal Dielectric Stability Thermal capability of an overhead line is a…
Zero Sequence Impedance of Transmission Line: Zero Sequence Impedance of Transmission Line - A fully transposed three-phase line is completely symmetrical and therefore the per phase impedance offered by it…
Derivation of Transmission Loss Formula: An accurate method of obtaining a general derivation of transmission loss formula has been given by Kron. This, however, is quite complicated. The aim of…
Voltage Profile of Transmission Line: Control of Voltage Profile of Transmission Line at the receiving bus in the fundamental two-bus system was discussed already. Though the same general conclusions hold…
Power Flow through Transmission Line: So far the transmission line performance equation was presented in the form of voltage and current relationships between sending-and receiving-ends. Since loads are more often…