You searched for HIGH VOLTAGE - Page 84 of 171

Clock Generator 8284A

Clock Generator 8284A: During fetch and execute instructions, the 8086 and 8088 processors require clock pulse which has about 10 ns rise and fall times. The logic 0 level of…

Pin Diagram of 80286 Microprocessor

Pin Diagram of 80286 Microprocessor: The Pin Diagram of 80286 Microprocessor is available in 68-pin PLCC (Plastic Leaded Chip Carrier), 68-pin Ceramic LCC (Lead Less Chip Carrier) and 68-pin PGA…

Series and Shunt Compensation of Transmission Lines

Series and Shunt Compensation of Transmission Lines: The performance of long EHV AC transmission systems can be improved by reactive compensation of series or shunt (parallel) type. Series capacitors and…

Blocked Rotor Test of Induction Motor

Blocked Rotor Test of Induction Motor: This Blocked Rotor Test of Induction Motor is used to determine the series parameters of the Circuit Model Parameters of an induction motor. The…

Performance of CMOS Gates

Performance of CMOS Gates: The Performance of CMOS Gates which based on following different categories namely, Operating Speed : Slower than TTL series. Approximately 25 to 100 ns depending on…

CMOS NAND Gate Circuit Diagram

CMOS NAND Gate Circuit Diagram: Fig. 3.3 shows CMOS NAND Gate Circuit Diagram 2-input NAND gate. It consists of two P-channel MOSFETs, Q1 and Q2, connected in parallel and two…

Conditions For Driving Point Function

Conditions For Driving Point Function: The restrictions on pole and zero locations in the Conditions For Driving Point Function with common factors in P(s) and Q(s) cancelled are listed below.…

Reactive Power with Wattmeter

Reactive Power with Wattmeter: We have already seen earlier that the difference between higher reading wattmeter and lower reading wattmeter yields VLIL sin Φ. So, the total reactive power =…